|9KW (100% Duty Cycle)
Preheat Induction Heater 10KW,
10KW PWHT Heating System,
Air cooled PWHT Heating System
10KW High Frequency Induction PWHT Machine 380V-460V
Induction heating offers a much faster time to temperature. The part reaches the desired temperature in a significantly shorter time
compared to traditional flame and resistance heating processes, allowing the job to get done faster.
Induction heating is a much safer heating process as there is no exposure to open flames or electrical resistance wires and less exposure to fumes compared to flame heating.
The faster heating time reduces costs due to less labour time, Plus there is no fuel costs or expensive ongoing inspection or audit costs associated with the Induction heating process.
Heating is maintained along and through the heat zone by using induction to heat within the material.
Easy To Set Up
Compared to resistance heating, induction heating is easy to set up and pull down, making it versatile to go from job to job. Plus, it offers
the flexibility to fit a variety of pipe diameters and plate lengths. Various Induction cable configurations can be adapted to suit your specific application.
In-built diagnostics enables operating parameters to be available at the touch of a button and offers operator tutoring. On-board temperature control provides for manual or temperature based programming in a simple-to-learn operator interface.
Reduce Heating Time by up to 400%
With the Miller Pro-Heat, a part can be brought to temperature in a faction of the time, compared to traditional flame and resistance heating processes. It also holds the part at the specified temperature. It can be programmed to hold and soak for a specified period of time. Pre-heat time can be reduced by up to 400%. To put this in perspective, companies using the Pro-Heat have reduced pre-heating time from over two hours to just 30 minutes.
With the introduction of theInduction Heating Machine, this simple and cost-effective heating process can be applied in the following applications to deliver fast and consistent heat:
- Welding fabrication and construction;
- Preheating of welds;
- Post-weld heat treatment;
- Coating removal;
- Shrink Fit
Pipe Fabrication Shops
Petrochemical – Construction/Repair
Mining Equipment Maintenance
Drill Pipe Manufacturing
|Input Amperes at Rated Output
|Thermal conversion efficiency
|More than 90%
|Maximum Rated output
|9KW at 100% duty cycle,3-35KHZ
|H:300MM W:245MM D:550MM
|By sea or By Air